1. Home
  2. Why is my robot’s floating cable getting tangled or wrapped around the robot?

Why is my robot’s floating cable getting tangled or wrapped around the robot?

There may be a couple of reasons for this:

  • Turn off the main pool pump when the robot is cleaning. If the pool pump is on, sometimes the water flow of the pool pump pushes the robotic cable over the robot while it is cleaning. On occasion, the cable will tangle with the robot when the robot is cleaning the walls of the pool.
  • The robot’s handle needs to be locked diagonally. Reverse the diagonal direction of the floating handle with each use. This will prevent the cable from tangling.
  • Do not put the entire cable into the water. Use only the required amount of cable necessary for the robot to cover the pool. Most robots have more than enough cable. For safety purposes, make sure the power supply is at least 12 feet (4 meters) from the pool.
  • Remove any additional flotation that may have been installed by you(the robot may be climbing the pool too high).
Does your Cable appear to be Damaged?

To avoid possible electrical shock, DO NOT use this product if the floating cable appears to be damaged! Call 1-800-845-4856 or Visit your nearest Service Center

Was this article helpful?

Leave a Comment